The RS8- L-DIN accepts voltage from 0 to 277 volts and up to 10amps at each load. The relays are single-pole, single throw, offering a set of eight latching contacts. This station may also be used as a low-voltage relay station. Actuator buttons allow the connected relays to be manually toggled. Relays latch in place retaining its last state in case of a power interrupt.

DIN Modules easily install on standard 35mm DIN rails. The station communicates with the main controller through a twowire bus using either screw terminals or a small connector on the side of the unit.

Key features:

• All relays are rated for Lighting type loads
• Provides a single integration point for up to eight relay channels
• Allows effortless control of devices such as lighting loads, draperies, pumps, garage doors, lifts, screens, pool covers, sprinklers, security systems, and much more
• Clips easily on standard 35mm DIN rails
• Communicates with the main controller through a two-wire bus or by a small connector on the side of the unit
• Includes individual switches for direct control of each of the eight relays

CONTROLLERS
ENCLOSURES
MODULES
TOUCHSCREENS
SENSORS
SOFTWARE

• DIN 8 Channel Relay Station/RS8-DIN
• DIN Contact Input Station/CIS10-DIN
• DIN Low Voltage Relay Station/LVRS8-DIN
• DIN Dimmer Standard Load Station 4/SLDS4-DIN
• DIN Dimmer Electronic Load Station 4/ELDS4-1-DIN
• DIN Dimmer Universal Load Station /ULDS1-DIN
• DINRelay Station Lighting/RS8-L-DIN
• 0-10 PWM Low Voltage Output Station-DIN / LVOS-0-10-PWM-DIN